Table of Contents
Advertisement
ated
●
When the vehicle is stopped by system
control on a steep incline
When any of the following are detected
●
while the vehicle is stopped by system
control:
• The driver's seat belt is unfastened
• The driver's door is opened
• Approximately 3 minutes have elapsed
since the vehicle was stopped
The parking brake may be activated auto-
matically.
●
Situations in which some or all of the
functions of the system cannot operate:
P.275
Dynamic radar cruise control system
■
warning messages and buzzers
For safe use: P.268
Preceding vehicles that the sensor may
■
not detect correctly
In the following situations, depending on the
conditions, if the system cannot provide suf-
ficient deceleration or acceleration is nec-
essary, operate the brake pedal or
accelerator pedal.
As the sensor may not be able to correctly
detect these types of vehicles, the approach
warning (P.321) may not operate.
When a vehicle cuts in front of your vehi-
●
cle or changes lanes away from your
vehicle extremely slowly or quickly
●
When changing lanes
When a preceding vehicle is driving at a
●
low speed
●
When a vehicle is stopped in the same
lane as the vehicle
●
When a motorcycle is traveling in the
same lane as the vehicle
■
Conditions under which the system may
not operate correctly
In the following situations, operate the
brake pedal (or accelerator pedal, depend-
ing on the situation) as necessary.
As the sensor may not be able to correctly
detect a vehicle, the system may not oper-
ate properly.
6-2. Using the safe driving support functions
When a preceding vehicle brakes sud-
●
denly
●
When changing lanes at low speeds, such
as in a traffic jam
Conditions for extended resume time
■
(Vehicles with Traffic Jam Assist)
Extended resume time is activated when all
of the following conditions are satisfied:
●
The vehicle is driving on a vehicle-only
road, such as an expressway.
There is a preceding vehicle and the sys-
●
tem is able to detect it.
●
No vehicle interruptions occur.
The preceding vehicle has not been
●
replaced.
●
Clearance sonar and FCTA are not
detecting the object in front of you.
●
The driver monitor judges that the driver
is looking forward.
The steering wheel has not been oper-
●
ated.
●
The brake pedal has not been operated.
Approach warning
In situations where the vehicle
approaches a preceding vehicle and
the system cannot provide sufficient
deceleration, such as if a vehicle cuts in
front of the vehicle, a warning display
will flash and a buzzer will sound to
alert the driver. Depress the brake
pedal to ensure appropriate vehi-
cle-to-vehicle distance.
Warnings may not occur when
■
In the following situations, the warning
may not operate even though the vehi-
cle-to-vehicle distance is short.
When the preceding vehicle is trav-
eling at the same speed or faster
than your vehicle
321
6
Advertisement
Table of Contents
