Table of Contents
Advertisement
Close & lock (Walk-Away) function
■
operating conditions (vehicles with
power back door)
This function can be operated when all of
the following conditions are met:
●
Close & lock (Walk-Away) function is
enabled.
An electronic key is not detected within
●
the vehicle.
●
All of the doors other than the power
back door are closed.
The brake pedal is not depressed.
●
●
The power switch is off.
The electronic key is within the effective
●
range (detection areas).
■
Situations in which the close & lock
(Walk-Away) function may not operate
properly (vehicles with power back
door)
In the following situations, the function may
not operate properly:
When the smart access system with
●
push-button start does not operate prop-
erly.
●
When the close & lock function does not
operate properly.
When moving away from the back door
●
while the close & lock (Walk-Away) func-
tion is in the standby state.
*
■
Close & lock function
tions (vehicles with power back door)
*
: This setting can be customized by your
Lexus dealer.
This function can be operated when all of
the following conditions are met:
An electronic key is not detected within
●
the vehicle.
All of the doors other than the power
●
back door are closed.
●
The power switch is off.
Situations in which the close & lock
■
*
function
may not operate properly
(vehicles with power back door)
*
: This setting can be customized by your
Lexus dealer.
In the following situations, the close & lock
function may not operate properly:
●
If the
power back door (P.101) is pressed by
a hand which is holding an electronic key.
●
If the
power back door (P.110) is pressed
when the electronic key is in a bag, etc.
that is placed on the ground
●
If the
power back door (P.110) is pressed
with the electronic key not near the vehi-
cle.
When reconnecting the 12-volt battery
■
To enable the power back door to operate
properly, close the back door manually.
■
Jam protection function (vehicles with
the power back door)
Sensors are installed in the right and left
sides of the power back door.
operating condi-
When the door is automatically closing and
the sensors are pushed due to an object
being clamped, the jam protection function
operates. From that position the door auto-
matically moves a little in the opposite
direction and then the function stops.
Customization
■
Some functions can be customized.
(P.585)
The back door can be
1-7. Loading luggage
switch on the lower part of the
switch on the lower part of the
switch on the lower part of the
Operating the back door using
the smart access system with
push-button start
107
1
Advertisement
Table of Contents
