Table of Contents
Advertisement
driving for 1 hour or more, perform the ID
code registration procedure again from
the beginning.
●
If the ID codes cannot be registered even
when performing the above procedure,
contact your Lexus dealer.
10
If the tire inflation pressure of the
wheel set installed differs from that
of the previous set, it will be neces-
sary to perform the tire inflation
pressure setting procedure of the
tire pressure warning system.
(P.449)
If the specified tire inflation pressure is the
same, it will not be necessary to perform
the tire inflation pressure setting proce-
dure.
Canceling ID code registration
To cancel ID code registration after it
has been started, select "New tire reg-
istration" again on the center display.
If ID code registration has been can-
celed, the tire pressure warning light
will turn off.
If the warning light does not turn off, ID
code registration may not have been
cancelled correctly. To cancel registra-
tion, select "New tire registration"
again on the center display.
Selecting wheel set
Your vehicle is equipped with a tire
pressure warning system with a
function to register two sets of ID
codes. This allows for registration of
a second wheel set, for example a
winter set.
8-5. Tire maintenance
The wheel set can be changed only
if a second wheel set has been regis-
tered to the system. If a second
wheel set has not been registered,
"Set 2(Unregistered)" will be dis-
played and it will not be possible to
change to the selected wheel set.
ID codes can be registered by yourself.
(P.451)
Only a change between both regis-
tered wheel set is possible, mixing
between these wheel sets is not sup-
ported.
While registering ID codes, it may
not be possible to change between
wheel sets normally. Cancel regis-
tration before changing between
wheel sets. (P.453)
1
Install the desired wheel set.
2
Select
on the center display.
3
Select "Vehicle customize".
4
Select "Tire pressure".
5
Select the wheel set ("Set 1" or "Set
2") displayed for the set selection
setting.
6
Select the wheel set you wish to
register, and then select "OK".
The tire pressure warning light will slowly
blink 3 times, a message indicating that
change is occurring will be displayed, and
the wheel set change will begin.
Wheel set change will begin and the tire
pressure warning light will blink for 1 min-
ute and then illuminate. Also, while the
change is being performed, "---" will be
displayed for the tire inflation pressure of
453
8
Advertisement
Table of Contents
