Replacing an RPI
Administration Terminal
P0725810 Issue 3.0
7. Close the cover.
8. Plug the RPI power cord to the ac outlet.
Note: The red light on each Base Station will flash for about
15 seconds while powering up. This is normal.
To replace an RPI, follow these steps:
1. Unplug the RPI power cord from the ac outlet.
2. Press the release catch with a screwdriver and open the cover.
3. Disconnect the wires from the RPI.
4. Remove the two bottom screws.
5. Lift up and remove the RPI.
6. Hang the new RPI on the two top screws.
7. Install and fasten the two bottom screws.
8. Re-connect all the wires to the RPI.
9. Close the RPI cover.
10. Plug the RPI power cord to the ac outlet.
Note: The red light on each Base Station will flash for about
15 seconds while powering up. This is normal.
To replace the Administration Terminal:
1. If the Administration Terminal is mounted on a wall, remove it
from its base.
2. Remove the telephone cord from the terminal marked
back of the Administration Terminal.
3. Plug the telephone cord in the terminal marked
of the new Administration Terminal.
4. If the Administration Terminal is mounted on a wall, remove the
base of the new Administration Terminal and snap the new
Administration Terminal on the wall-mounted base.
COMPANION 200 Installation and Maintenance Guide
Replacing equipment 146
at the
at the back