93 Programming the COMPANION 200
System time
COMPANION 200 Installation and Maintenance Guide
• System LID
• Radio antenna type
Note: Program the time and date immediately after your
COMPANION 200 system is operational. You will have to
reprogram the time twice a year because of Daylight Savings
Time. The time should also be reprogrammed if the power is
OFF for more than three days.
To set the system time, follow these steps:
1. Enter Administration programming.
2. Press * or & until the display shows
5. Time and Date.
3. Press ^. The display shows Time followed by the
current system time.
4. Press CHANGE. The display shows Hour:, followed by the current
system hour. If you don't want to change the hour, go to step 7.
5. Press CHANGE The display shows Hour: _.
6. Enter the hour in 12- or 24-hour format, as one or two digits.
7. Press *. The display shows Minutes:, followed by the
current system minutes. If you don't want to change the minutes,
go to step 10.
8. Press CHANGE. The display shows Minutes: _.
9. Enter the minutes as one or two digits, for example 1or 01.
10. Press *. If you entered an hour less than or equal to 12,
the display prompts you with AM or PM. If you entered an hour
greater than 12, go to step 12.
11. Press CHANGE to select AM or PM.
12. Press * to set the date, or % twice to continue
in Administration programming.
P0725810 Issue 3.0