Nortel Meridian Companion Installation And Maintenance Manual page 123

Checking when an event occurred
Checking the highest severity alarm
Checking consecutive repetitions of an event or alarm
Erasing the log
P0725810 Issue 3.0
2. Press * or & until the display shows
5.Admin Log.
3. Press ^. The display shows Start of new log or
Start of log.
4. Use * or & to scan the events in the log.
5. To continue in maintenance, press % twice.
To check when an event occurred, follow these steps:
1. Enter the Administration log.
2. Use * or & to scan the events in the log.
3. Press TIME at the event whose time you want to know. The
display shows the date and time that the event last occurred, then
returns to its previous display.
To check the highest severity alarm, follow these steps:
1. Enter the Administration log.
2. Press ALARM. The display shows an alarm code if there is an
uncleared alarm, or No current alarm (see "Understanding
alarm messages" to deal with the alarm).
To check repetitions of an event or alarm, follow these steps:
1. Enter the Administration log.
2. Use * or & to scan the events in the log.
3. Press REPEAT at the event whose number of repetitions you want
to know. The display shows the number of consecutive times that
the event or alarm occurred, then returns to its previous display.
To erase the log, follow these steps:
1. Enter the Administration log.
2. Press ERASE. The display shows Erase log?.
3. Press YES. If no new events have been added since the list was
entered, the log is erased and the display shows Log is empty,
then 5.Admin Log. If new events have been added since the list
was entered, the display shows Log has changed.
COMPANION 200 Installation and Maintenance Guide
Maintenance 124