Changing The Registration Password - Nortel Meridian Companion Installation And Maintenance Manual

91 Programming the COMPANION 200

Changing the Registration password

COMPANION 200 Installation and Maintenance Guide
!
Record your password.
Record any password changes in the COMPANION 200
Programming Record. If you forget the Installer password you will
not be able to enter Programming, Maintenance, Memory Reset, or
System Startup.
The Installer password must have at least one digit and no more than
six digits.
1. Enter Configuration programming.
2. Press * or & until the display shows
2.Miscellaneous.
3. Press ^. The display shows Link Time: followed by the
currently programmed Link time.
4. Press * until the display shows Installer pswd..
5. Press CHANGE. The display shows New pswd: _..
6. Enter a new one- to six-digit Installer password. Use BKSP to
correct your entry if necessary. When done, press OK. The
display shows Re enter: _.
Note: If you do not enter any digits and press OK, the display
shows Pswd not changed.
7. Re-enter the digits and press OK. The display should show
Password changed. If the display shows Pswd not changed,
you did not enter the same password again. Go back to step 5 and
repeat the process.
8. Record the new Installer password in the COMPANION 200
Programming Record.
You must enter the registration password on each portable to
successfully register it with the COMPANION 200 system. The
default is ‡¤‹›fl (or ÂÅÎÈØ), but you should set
your own password. You can choose any combination of one to six
P0725810 Issue 3.0