Configuration Programming - Nortel Meridian Companion Installation And Maintenance Manual

89 Programming the COMPANION 200
Time and date
Adjusting the contrast

Configuration programming

COMPANION 200 Installation and Maintenance Guide
If an alarm message appears on the Administration Terminal's
display:
1. Note the alarm code.
2. Follow the procedures in "Alarm troubleshooting" for the given
alarm to determine the cause of the alarm.
3. To see when the alarm occurred, press TIME.
4. To clear the alarm, press CLEAR.
When a problem occurs, alarm codes can take up to two minutes to
be displayed on the Administration Terminal. If the Controller was
turned off when the failure occurred, the alarm code appears two
minutes after the Controller is turned on.
The current system time and date are displayed on the properly
functioning Administration Terminal when it is idle. It is important
to ensure that the time and date displayed are correct because your
COMPANION 200 system uses these values when logging
Maintenance messages.
If you find the Administration Terminal display hard to read, you can
adjust the contrast.
Note: This feature will not work while you are in a Configuration,
Maintenance, or Administration session.
To adjust the contrast, follow these steps:
1. Press ƒ•‡ on the Administration Terminal.
2. The display will show Contrast level followed by the current
contrast level expressed as a digit.
3. To select a new contrast level, press a dialpad number button. (0
is the lowest setting and 9 is the highest setting.) You may also
press DOWN or UP to set the new contrast level.
4. When the contrast level you want is displayed, press OK.
To enter Configuration programming:
1. Press ƒ••¤flfl‹››. The display shows
Password:.
P0725810 Issue 3.0