Power Bar; Rpi - Nortel Meridian Companion Installation And Maintenance Manual

145 Replacing equipment

Power bar

RPI

Replacing an RPI Power Supply Unit
COMPANION 200 Installation and Maintenance Guide
7. Remove the cable trough screws.
8. Apply gentle upward pressure to the Base Station Module and
lift it away from the mounting bracket.
9. Carefully install the new Base Station Module onto the mounting
bracket.
10. Fasten the cable trough to the wall using two 38-mm screws.
11. Re-install the power bar (if any) in the cable trough.
12. Re-connect the 25-pair cables and fiber cable to the connectors
from which they were removed.
13. Fasten the RJ21 connector latch screw.
14. Re-connect the power cord to the ac outlet or power bar.
To replace a power bar, follow these steps:
1. Unplug the power bar from the ac outlet or power bar.
2. Remove the power cords connected to the power bar.
3. Slide out the power bar.
4. Slide in the new power bar.
5. Connect the power cords to the power bar.
6. Connect the power bar to the ac outlet or power bar.
To replace an RPI Power Supply Unit, follow these steps:
1. Unplug the RPI power cord from the ac outlet.
2. Press the release catch with a screwdriver and open the cover.
3. Disconnect the jumper lead, grounding plates, grounding strap
and cable from the connection board.
4. Unscrew the power supply unit and remove it.
5. Place the new power supply unit and fasten its screws.
6. Connect the jumper lead, grounding plates, grounding strap, and
cable to the connection board.
P0725810 Issue 3.0