Running Data Re-Evaluation - Nortel Meridian Companion Installation And Maintenance Manual

Running Data Re-evaluation

P0725810 Issue 3.0
can adapt to these changes and provide optimum performance. All
active calls will be dropped when Data Re-evaluation begins. To
minimize the effects of Data Re-evaluation on the system, you can
schedule it to run at a time of your choice.
Please be aware that:
• If the system detects the need for Data Re-evaluation, you will see
Re Eval Required on the Administration Terminal.
• Approximate run times for Data Re-evaluation are shown in the
Powering up section.
• If a Base Station is removed or added while Data Re-evaluation
is running, the re-evaluation procedure will take twice as long to
complete.
!
Data Re-evaluation disables the COMPANION 200
system.
All active calls will be dropped when Data Re-evaluation begins.
!
Skipped or delayed Data Re-evaluation.
To avoid skipped or delayed Data Re-evaluation ensure that the
system's internal clock is set to the correct time. This is particularly
important after system start-up.
1. Enter Configuration programming.
2. Press * or & until the display shows
3. Radio Data.
3. Press ^. The display shows Re-Evaluation.
4. Press ^. The display shows Re-Eval status.
5. Press ^. The display shows Re-Eval required (the
COMPANION 200 system has detected a need for Data Re-
evaluation), or Re-Eval not req. (the COMPANION 200
system did not detect the need for Data Re-evaluation), or Re-
Eval in prog. (the COMPANION 200 system is currently
running Data Re-evaluation).
6. Press CONTINUE. The display shows Re-Evaluate now?
COMPANION 200 Installation and Maintenance Guide
Programming the COMPANION 200 100