Nortel Meridian Companion Installation And Maintenance Manual page 171

P0725810 Issue 3.0
Appendix E: Installing Base Station plug-top power supplies 172
4. Wind any excess cable around the posts to secure it, then fasten
it under the strain relief.
Figure 42: Base Station bracket detail
Strain relief tab
Base Station
termination
board
5. Connect the wires to the connector on the termination board as
shown in the following illustration.
Note: The polarity of the TCM connections is not important.
Figure 43: Bracket termination board
RJ11 jack
6. Mount the Base Station onto the bracket, snapping it into
position.
7. Connect the power RJ11 jumper lead to the RJ11 jacks on the
termination board and the Base Station.
COMPANION 200 Installation and Maintenance Guide
Bracket mounting
screw hole
TCM
-PWR(1)
-PWR(2)
Base Station
mounting
bracket
Telephone
line cord
Base Station
mounting
clips
Bracket mounting
screw hole
Power supply connector
Strain relief tab
Power supply cord
TCM
+PWR(1)
+PWR(2)