Nortel Meridian Companion Installation And Maintenance Manual page 74

75 Installing the hardware
COMPANION 200 Installation and Maintenance Guide
in the illustrations). Allow for the following clearance around the
Base Station:
Figure 32: Clearance for the Base Station
30 cm
30 cm
30 cm
Base Station
To mount a Base Station, follow these steps:
1. Fasten the bracket into position using two screws.
2. Route the cable from the Controller through the top (or bottom)
opening.
3. Wind any excess cable around the posts to secure it, then fasten
it under the strain relief.
Figure 33: Base Station bracket detail
Strain relief tab
Base Station
termination
board
4. Connect the wires to the Krone or BIX connector on the bracket
termination board as shown in the following illustration.
Base Station
39 cm
30 cm
Cover
Bracket mounting
screw hole
37 cm
39 cm
30 cm
Bracket
Base Station
mounting
bracket
Telephone
line cord
Base Station
mounting
clips
Bracket mounting
screw hole
Strain relief tab
P0725810 Issue 3.0