Nortel Meridian Companion Installation And Maintenance Manual page 45

P0725810 Issue 3.0
Note: Do not remove the door of the Base Station Module during
the installation.
!
To avoid overheating, mount the Base Station Module
on the wall.
!
Install with the power OFF.
The Base Station Module power must remain disconnected during the
installation.
To mount a Base Station Module, follow these steps:
1. Position the mounting bracket.
Allow for the following clearance around the mounting bracket:
Top: Leave about 15 cm of space above the screw holes of the
mounting bracket. This clearance gives you enough room to lift
the Base Station Module on and off the bracket, and provides
space for venting the heat from the Base Station Module.
Bottom: Leave at least 15 cm of space between the bottom of
the cable trough and the floor, or any object that may block the
flow of air from the bottom. This prevents the Base station
Module from overheating.
Left and right: Leave enough room to open the door of the Base
Station Module and to run cabling out to the side.
Note: The space between two modules hung on the mounting
brackets is approximately 3 mm.
2. Fasten the mounting bracket to the wall using two 19-mm screws
as shown in the following illustration.
COMPANION 200 Installation and Maintenance Guide
Installing the hardware 46