Summary; Mounting The Remote Power Interconnect Unit - Nortel Meridian Companion Installation And Maintenance Manual

Summary

Mounting the Remote Power Interconnect unit

P0725810 Issue 3.0
To install an RPI, you must:
1. Mount the RPI.
2. Wire the RPI.
To upgrade an RPI-8 to an RPI-16, you must:
1. Power down the RPI.
2. Install the second power supply unit.
3. Wire the RPI.
4. Power up the RPI
!
Do not power the RPI until the installation is complete.
1. Position the screw holes for the RPI using the dimensions shown
in the following illustration.
To provide adequate ventilation and to prevent overheating,
leave a clearance of at least 15 cm around the RPI.
If you are mounting two RPIs, one above the other, leave a
clearance of at least 30 cm between them to provide adequate
ventilation and to prevent overheating.
2. Partially screw in two 4-mm, 5-cm long screws for the keyholes.
3. Open the hinged cover by levering the release catch on the right
side with a screwdriver. If you wish, remove the cover by lifting
it off its hinges.
COMPANION 200 Installation and Maintenance Guide
Installing the hardware 52