Nortel Meridian Companion Installation And Maintenance Manual page 100

101 Programming the COMPANION 200
Scheduling Data Re-evaluation
COMPANION 200 Installation and Maintenance Guide
7. If you want to run Data Re-evaluation later, press NO and see
"Setting a schedule time". If you want to run Data Re-evaluation
now, press YES. The display shows Calls will drop.
!
Data Re-evaluation cannot be canceled.
To exit with no impact, press
8. Press EXECUTE. The display shows Re-Eval in prog..
9. Press ® to exit. The display shows Re-Eval in prog.. Press
CLEAR to remove the message.
10. When Data Re-evaluation is complete, the display shows Re-
Eval complete. To remove the message, press CLEAR .
Verifying the scheduled time
1. Enter Configuration programming.
2. Press * until the display shows 3. Radio Data.
3. Press ^. The display shows Re-Evaluation.
4. Press ^. The display shows Re-Eval status.
5. Press *. The display shows Re-Eval schedule.
6. Press ^. The display shows the time and date for which
Data Re-evaluation has been scheduled, or Not scheduled.
7. If the time and date displayed are OK, press % three
times to continue in Configuration. To schedule Data Re-
evaluation or change the scheduled time, go to step 2 of "Setting
a scheduled time." To cancel a scheduled Data Re-evaluation,
press CANCEL.
Setting a scheduled time
Note: The system only accepts a date and time set later than the
current date and time.
1. Press ^. The display shows Not scheduled.
2. Press CHANGE. The display shows Calls will drop at set
time, then Time followed by the currently scheduled hour, or
0:01 if not scheduled.
or CANCEL.
®
P0725810 Issue 3.0