Registering The Portables - Nortel Meridian Companion Installation And Maintenance Manual

105 Programming the COMPANION 200

Registering the portables

COMPANION 200 Installation and Maintenance Guide
When the system begins the Data Re-evaluation procedure, the
display shows Re Eval in prog.. When the re-evaluation
procedure is completed, the display shows Re Eval complete.
Clear the message using CLEAR.
Note: To see approximate run times for Base Station download
and Data Re-Evaluation, refer to the Powering up section.
Note: If a Base Station is turned on or off while Data Re-
evaluation is running, the re-evaluation procedure takes
twice as long to complete.
6. Re-program the system.
Before a portable will operate, you must register it with the system.
Ensure that you are within range of a COMPANION 200 Base
Station when you register the portables.
Note: When you power up the Controller for the first time, or after
a prolonged power failure, you can register up to eight
portables on the system. The system coordinator can register
additional portables after obtaining software keys for
portable registration credits. For more information, see the
COMPANION Operations Guide.
When distributing the portables, inform the users that the portables
are registered and give them the corresponding slot numbers.
To register the portables, you carry out the following tasks:
• enable registration for the COMPANION 200 system
• register the portables (see your Companion Portable Telephone
Registration Instructions)
• verify the portable operation
• disable registration for the COMPANION 200 system
P0725810 Issue 3.0