Nortel Meridian Companion Installation And Maintenance Manual page 125

Table 14: Alarm codes
Alarm:50-xxxx
Alarm:51-xxxx
Alarm:52-xxxxn
Alarm:53-xxxxn
Alarm:56-xxxxn
Alarm:67-xxxx
Alarm:68-xxxx
Re-Eval Required
Re-Eval in prog.
Re-Eval complete
BS- 1 Dload Start
BS- 1 Dload Stop
P0725810 Issue 3.0
(continued)
All Base Station Module TCM
lines disconnected.
All Line Module access lines
disconnected.
Line Cartridge n disconnected. A Line Cartridge has been disconnected from the Line
Internal Base Station error.
Device failure
Wrong Line Cartridge.
Wrong device.
The COMPANION 200 has
detected a need for Data
Re-evaluation.
Normal operation.
Normal operation.
Normal operation.
Normal operation.
All the TCM lines on the Base Station Module connected to
port xxxx on the Expansion Cartridges have been
disconnected.
The 25-pair cable was disconnected from the Base Station
Module.
There is an internal Base Station Module fault.
All the access lines on the Line Module connected to port
on the Expansion Cartridges have been
xxxx
disconnected.
The link cable was disconnected from the Line Module or the
Controller.
There is an internal Line Module fault.
Module connected to port
Cartridges.
The Base Station on port
an internal error. If a link is active when this error occurs, the
link is dropped (n identifies the Base Station radio).
Base Station radio or RAD has failed.
The Line Cartridge on port
software.
The device connected to port
the software.
There is a non-Base Station device in port
A new Base Station was added to the system.
A Base Station was moved to a different port.
A Base Station was replaced with a new Base Station.
Data Re-evaluation is running.
Data Re-evaluation is finished.
The Controller is downloading Base Station data.
The Controller has finished downloading Base Station data.
COMPANION 200 Installation and Maintenance Guide
Maintenance 126
xxxx on the Expansion
has been disabled due to
xxxx
xxxx is not compatible with the
xxxx is not compatible with
xxxx .