Module Status; Checking The State Of A Module - Nortel Meridian Companion Installation And Maintenance Manual

Module status

Checking the state of a module

P0725810 Issue 3.0
1. Enter a Maintenance session.
2. Press * or & until the display shows 2.Port
Status.
3. Press ^. The display shows Show port: _.
4. Enter the number of the port you want to examine, or press
^ to see port 0101.
5. Press STATE. The display shows the current state of the device.
6. Press the ENABLE key. The display shows Enabling..., then the
state of the device.
7. Press % twice to continue in Maintenance.
Module status lets you check the status of the Line Modules or Base
Station Modules, and disable or enable them.
Module Associated equipment
01 Controller TCM lines (Base Stations, Administration
Terminal, RAD).
02 Controller access lines.
03–14 Base Station Modules (Base Stations) and Line Modules
(access lines).
To check the state of a module, follow these steps:
1. Enter a Maintenance session.
2. Press * or & until the display shows
3.Module Status.
3. Press ^. The display shows Show module: _.
4. Enter the module number you want to examine, or press
^ to see the first module. The display identifies how
many devices are attached to the module.
To verify the state of a Line Cartridge, press LC. The display
shows the number of lines on Line Cartridge 1. Press *
or & to view the other Line Cartridges.
5. Press STATE. The display shows the state of the devices on the
module (see the following chart).
COMPANION 200 Installation and Maintenance Guide
Maintenance 118