Nortel Meridian Companion Installation And Maintenance Manual page 105

Enabling and disabling registration
Verifying a portable's operation
Deregistering an access line
P0725810 Issue 3.0
You must enable registration for the entire COMPANION 200
system to allow individual portables to register. The options are Yes
(Y) and No (N). Yes indicates that master registration is enabled. No
is the default and indicates that master registration is not enabled.
Note: To prevent interference problems with neighboring systems,
set the master registration to Yes when the portables are
being registered.
To enable registration, follow these steps:
1. Enter Administration programming.
2. Press * or & until the display shows 1. Reg.
Control.
3. Press ^. The display shows Mstr Reg Enbl:, followed
by the currently set master registration option.
4. To change to the other setting option, press CHANGE .
5. To continue in Administration programming, press % .
After you register a portable, verify that
• the line number you entered during registration corresponds to
the portable's telephone number
• the portable can make calls
Follow these steps:
1. Verify that the portable has a dial tone (ensure that the portable's
twinned desk telephone, if any, is idle).
2. On another telephone, dial the number that maps to the
registered access line.
3. If the portable rings, it is functioning properly.
If the portable does not ring, try to register the portable again.
4. Place a call using the portable. If you are unable to place a call,
follow the procedures in "Troubleshooting a portable" in the
troubleshooting section.
To register a portable on an access line number that is currently
registered to another portable, or to deregister the portable assigned
to that access line, you must first deregister the access line number.
COMPANION 200 Installation and Maintenance Guide
Programming the COMPANION 200 106