Nortel Meridian Companion Installation And Maintenance Manual page 97

P0725810 Issue 3.0
the letters A to F) between 0401 and FFFE. The default is randomly
generated by the system at startup.
Note: The System LID should only be changed if an adjacent
wireless system has the same System LID.
!
Changing the System LID deregisters all portables.
If you change the System LID, you will invalidate the registration of
all the portables on the system. Portables will have to be re-registered
before they can be used with the system.
Only an Installer should change the System LID.
To change the System LID, follow these steps:
1. Enter Configuration programming.
2. Press * or & until the display shows
3. Radio Data.
3. Press ^. The display shows Re-Evaluation.
4. Press *. The display shows Radios.
5. Press * until the display shows System LID:, followed
by the currently programmed System LID.
6. Press CHANGE. The display shows System LID:_.
7. To enter one of these numbers, 1, 4, 5, 6, 7, 8, 9, 0, press the
corresponding dialpad button.
To enter one of the these characters, A, B, C, D, E, F, 2, 3, press
the dialpad button indicated in the following table until the
desired character is displayed.
Character:
A, B, C, 2
D, E, F, 3
8. When you have entered the desired character, press --> to move
the cursor to the next character position.
9. Repeat steps 7 and 8 until all four characters are entered. To
correct a character, press <-- or --> to move the cursor back to
that character, and repeat step 7.
10. Press OK. If the LID entered is valid, the display shows LID
changed, then System LID:, followed by the new System LID.
COMPANION 200 Installation and Maintenance Guide
Programming the COMPANION 200 98
Dialpad button
¤
‹