Software Cartridge; Line Cartridge - Nortel Meridian Companion Installation And Maintenance Manual

Software Cartridge

Line Cartridge

P0725810 Issue 3.0
!
Wear a Grounding Strap.
Do not touch the printed circuit board or the connector.
The printed circuit board of theSoftware Cartridge is a static-
sensitive device.
!
Unplug the Controller before replacing a Software
Cartridge.
1. Unplug the power cord from the ac outlet or power bar.
2. Remove the Software Cartridge from its slot.
3. Holding it vertically, insert the new Software Cartridge in its
slot.
4. Plug the power cord into the ac outlet.
Note: If the Base Station software version in the new Software
Cartridge does not match that of one or more Base Stations,
the system will download the Software Cartridge Base
Station software version to those Base Stations (see "Base
Station software downloading" in the section Powering up).
1. Unplug the power cord from the ac outlet or power bar.
2. With the latches open, remove the Line Cartridge from its slot.
3. With the latches open, insert the new Line Cartridge in its slot
and close the two latches simultaneously to align the cartridge
properly.
4. Plug the power cord into the ac outlet or power bar.
COMPANION 200 Installation and Maintenance Guide
Replacing equipment 142