Nortel Meridian Companion Installation And Maintenance Manual page 129

Table 16: Event messages (continued)
Event code
EVT304-01032
EVT305-01032
S5
EVT306-01031
S5
EVT307-0109100 S5
EVT307-0109101 S5
EVT307-0109102 S5
EVT308-0103 S8
EVT 400
EVT 412
EVT 413
EVT-414
EVT-415
EVT 416
EVT 417
P0725810 Issue 3.0
Meaning
A B2 channel radio (radio 2 on port 0103 in this case) cannot be synchronized
with other radios because of system overload.
A B2 channel radio (radio 2 on port 0103 in this case) cannot be synchronized
because the B1 radio was disabled in maintenance.
Both radios belonging to the Base Station (on port 0103 in this case) will be
disabled. The B1 radio must be operational to synchronize both radios of the
Base Station with other radios in the system. Two events are raised: one for the
B1 channel radio and another for the B2 channel radio. A corresponding
alarm code 53 will occur.
A radio (0103-1 in this case) cannot be synchronized because there are no B2
channel radios.
Both radios belonging to the Base Station (0103 in this case) will be disabled.
Two events are raised: one for the B1 channel radio (as in this case) and
another for the B2 channel radio. A corresponding alarm code 53 will occur.
A recoverable RIM fault has occurred.
The RIM will be reset. If a link is active when this error occurs, the link is
dropped. The radio (0109-1 in this case) is returned to service.
An unrecoverable RIM fault has occurred.
The radio (0109-1 in this case) will be disabled and taken out of service. If a
link is active when this error occurs, the link is dropped. A corresponding alarm
code 53 will occur.
The built-in self-test on the Base Station has failed.
The radio (0109-1 in this case) will be disabled and taken out of service. If a
link is active when this error occurs, the link is dropped. A corresponding alarm
code 53 will occur.
The Base Station is connected to a system that supports a radio protocol that
the Controller does not understand.
System is being restarted
The installer password has been changed. The parameter contains the
extensi on number that changed the password
The Administration password has been changed. The parameter contains the
extension number that changed the password.
Someone tried to enter the system with an invalid installer password.
Someone tried to enter the system with an invalid administration password.
Someone has initiated a Configuration programming session.
Someone has initiated an Administration programming session.
COMPANION 200 Installation and Maintenance Guide
Maintenance 130