Verifying The Installation; Verification Checklist - Nortel Meridian Companion Installation And Maintenance Manual

Verification checklist

P0725810 Issue 3.0

Verifying the installation

After the system has been installed and programmed, verify that it is
operating as intended. Use the following steps to complete this task.
1. Compare the programming performed (as recorded in the
COMPANION 200 Programming Record) against the planned
programming to ensure there are no errors.
2. Verify that all the devices are active (see "Checking the state of
a device" in the Maintenance section).
3. For each radio, verify that its antenna setting is correct (see
"Verifying a radio's antenna setting").
4. For each cell center in the system, verify that you can establish a
connection with all the radios at that cell center.
a. Stand in the neighborhood of the cell center and measure the
Receive Signal Strength Indicator (RSSI) several times
using undirected RSSI until you have connected to all the
radios at that cell center (see your COMPANION 200
Portable Telephone Registration Instructions for instructions
on measuring the RSSI).
Note:
Note: Radios are identified by five-digit numbers. The first four
digits indicate the TCM port to which the Base Station is
connected. The fifth digit indicates the number of the
radio on the Base Station, either 1 or 2. For example, the
number 03051 identifies radio 1 on the Base Station
connected to TCM port 0305.
Note: You can also use directed RSSI to verify the
connection to a radio (see your COMPANION 200
Portable Telephone Registration Instructions).
COMPANION 200 Installation and Maintenance Guide
108