Mounting The Administration Terminal On The Wall - Nortel Meridian Companion Installation And Maintenance Manual

73 Installing the hardware

Mounting the Administration Terminal on the wall

COMPANION 200 Installation and Maintenance Guide
8. Connect one end of the telephone cord to the terminal marked
at the back of the Administration Terminal, and the other
to port 0101 on the Controller.
To mount the Administration Terminal on the wall, follow these
steps:
1. Remove the wall-mounting bracket from the base of the
Administration Terminal. Grip the base, and with both thumbs,
push on the top to pop it out.
Figure 30: Removing the Administration Terminal wall-mounting bracket
2. Use a screwdriver or similar tool to remove the center knock-out
panel from the base.
Figure 31: Removing the knock-out panel
3. With the thin end up, hold the base against the wall and mark the
positions of the three fixing screws.
4. Route the line cord along the guide in the base and through the
knocked-out hole.
5. Screw the mounting base to the wall.
6. Connect the line cord into the
Administration Terminal.
Base
Terminal
Knock-out panel
Base
terminal in the base of the
P0725810 Issue 3.0