Base Station Module
P0725810 Issue 3.0
3. Loosen the RJ21 connector latch screw and unplug the 25-pair
cable from the Line Module.
4. Unplug the fiber cable from the Line Module.
5. Remove all cables from the cable trough.
6. Remove the power bar (if any) from the cable trough.
7. Remove the cable trough screws.
8. Apply gentle upward pressure to the Line Module and lift it
away from the mounting bracket.
9. Carefully install the new Line Module onto the Mounting
bracket.
10. Fasten the cable trough to the wall using two 38-mm screws.
11. Re-install the power bar (if any) in the cable trough.
12. Remove the Line Cartridges from the old Line Module and
install them in the new Line Module.
13. Re-connect the 25-pair cables and fiber cables to the connectors
from which they were removed.
14. Fasten the RJ21 connector latch screw.
15. Re-connect the power cord to the ac outlet or power bar.
!
Wear a Grounding Strap.
Replacing a Base Station Module will interrupt normal
COMPANION 200 service.
To replace a Base Station Module, follow these steps:
1. Unplug the power cord from the ac outlet or power bar.
2. Open the door of the Base Station Module.
3. Loosen the RJ21 connector latch screw and unplug the 25-pair
cable from the Base Station Module.
4. Unplug the fiber cable from the Base Station Module.
5. Remove all cables from the cable trough.
6. Remove the power bar (if any) from the cable trough.
COMPANION 200 Installation and Maintenance Guide
Replacing equipment 144