An Ospf Route Is Not In The Routing Table; Ecmp Maximum Path For Ospf - Avaya Virtual Services Platform 7000 Series Troubleshooting Manual

3. Observe and note the Priority setting of each OSPF-enabled interface.
4. Repeat steps 1 through 3 for other OSPF neighbor switches.
Configuring OSPF interface router priority
Configure the router priority on at least one OSPF-enabled interface to a value of 1 or greater.
Procedure
1. Enter Ethernet Interface Configuration mode:
enable
configure terminal
interface Ethernet <port>
2. Enter the ip ospf priority <1–255> command.

An OSPF route is not in the routing table

This section describes the troubleshooting process you can use to diagnose and resolve an OSPF
route missing from the routing table.

ECMP maximum path for OSPF

Ensure the ECMP maximum path value for OSPF is greater than 1.
If the maximum number of ECMP paths for use by OSPF is set to 1, only one OSPF route is added
into routing table for a reachable destination.
Checking the IP route table
Verify that the OSPF route does not appear in the IP route table.
Procedure
1. Log on to ACLI to enter User EXEC mode.
2. Enter the show ip route command.
3. Check the IP route table for the OSPF route.
Checking the ECMP maximum path setting for OSPF
Display and observe the ECMP maximum path setting for OSPF.
Procedure
1. Log on to ACLI to enter User EXEC mode.
July 2015
Comments on this document? infodev@avaya.com
An OSPF route is not in the routing table
Troubleshooting Avaya VSP 7000 Series
85