Siemens SINUMERIK 840D Diagnostics Manual page 677

03.04
No. 100
Explanation
Not allowed if
Remedy
No. 101
Explanation
Not allowed if
Remedy
No. 102
Explanation
Not allowed if
Remedy
No. 103
Explanation
Not allowed if
Remedy
No. 104
Explanation
Not allowed if
Remedy
No. 105
Explanation
Not allowed if
Remedy
No. 106
Explanation
Not allowed if
Remedy
No. 107
Explanation
Not allowed if
Remedy
No. 108
Explanation
Not allowed if
Remedy
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Integrated block search, i.e., a block search is restarted on a stopped program.
-
-
External zero offset is activated via the PLC. Movement is stopped, a Reorg is performed,
the interpreter is switched over and then selected using REPOS and continued automati-
cally.
1. The channel is not in AUTO or MDA.
2. The channel is stopped and the current block cannot be reorganized.
> Select AUTO or MDA.
> Activate block change until the NC block can be reorganized.
Single block type 3 is activated. With single block type 3, a stop is performed at all main
blocks. Unlike single block type 1, the part program command SBLOF is ignored.
-
-
Stopping of a single axis movement (VDI signal)
The axis is not controlled by the PLC (exception old reaction with oscillation axis).
-
Stopping of a single axis movement by an alarm
The axis is not controlled by the PLC (exception old reaction with oscillation axis).
-
Continuation of a single-axis movement (VDI signal).
The axis has not been stopped previously. Not for all axis types at present.
-
Interruption of a single-axis movement (VDI signal).
The axis is not controlled by the PLC. Not for all axis types at present.
-
Deletion of distance-to-go of a single-axis movement (VDI signal).
The axis is not controlled by the PLC. Not for all axis types at present.
-
Power UP: Axis is now controlled by the PLC (VDI signal).
The axis is not controlled by the PLC. Not for all axis types at present.
-
1 Alarms
1-677