Siemens SINUMERIK 840D Diagnostics Manual page 676

1 Alarms
No. 91
Explanation
Not allowed if
Remedy
No. 92
Explanation
Not allowed if
Remedy
No. 93
Explanation
Not allowed if
Remedy
No. 94
Explanation
Not allowed if
Remedy
No. 95
Explanation
Not allowed if
Remedy
No. 96
Explanation
Not allowed if
Remedy
No. 97
Explanation
Not allowed if
Remedy
No. 98
Explanation
Not allowed if
Remedy
No. 99
Explanation
Not allowed if
Remedy
1-676
Start continuation of interpreter processing (internal preprocessing stop).
-
-
Save interlock for data.
The channel is not in the "stopped" state.
-
Activate user data, e.g., via MMC; newly modified tool lengths are effective immediately in
the running program.
1. The channel is not in the "stopped" state.
2. The channel is stopped and the current block cannot be reorganized.
> Press the Stop/Single-Block/Reset/StopAtEnd (Automatic) key.
> Activate a block change until the NC block can be reorganized.
Write the user PLC version to the version file.
-
-
Switch measuring systems (PI command).
-
-
Shut down system (VDI signal).
-
-
Activate block search PI (program invocation) in mode 5. This mode simulates the block
search, in which the program under "Program test operation" is processed as far as the
target of the block search.
-
-
Extended stop and retract
-
-
Block search (general) is currently being activated (negative acknowledgement may be
output for PI service).
-
-
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
03.04