Siemens SINUMERIK 840D Diagnostics Manual page 119

10.04
Reactions:
Remedy:
Program Continuation:
10774
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10775
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10776
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 illegal tool dimensions with face cutting in block %2
%1 = Channel number
%2 = Block number, label
This alarm occurs when illegal tool dimensions are programmed for face milling, e.g. neg-
ative tool radius, rounding radius zero or negative for tool types that require a rounding
radius, taper angle zero or negative for tapered tools.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 illegal tool change with face cutting in block %2
%1 = Channel number
%2 = Block number, label
This alarm occurs when a tool change has been programmed while 3D tool radius com-
pensation is active with the result that the tool type changes or, if the tool type remains
unchanged, at least one relevant tool dimension has changed as compared with the dese-
lected tool. Depending on the tool type, relevant tool dimensions can be the tool diameter,
the rounding radius or the taper angle. Changes to the tool length are allowed.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block%2 axis %3 must be geometry axis if tool radius compensation is
active
%1 = Channel number
%2 = Block number, label
%3 = Axis name
This alarm occurs when an axis that is required for tool radius compensation is not a
geometry axis. With CUT2DF, the axis can be a positioning axis perpendicular to the
machining plane; with all other types of compensation (CUT2DF, CUT3DC, CUT3DF,
CUT3DFF), all geometry axes must be operated as such.
1 Alarms
1-119