Siemens SINUMERIK 840D Diagnostics Manual page 499

10.04
103008
Parameters:
Definitions:
Remedy:
Program Continuation:
103009
Definitions:
Remedy:
Program Continuation:
103010
Definitions:
Remedy:
Program Continuation:
103011
Definitions:
Remedy:
Program Continuation:
103014
Definitions:
Remedy:
Program Continuation:
104000
Definitions:
Remedy:
Program Continuation:
104001
Definitions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Block search in channel %1 started - please wait
%1 = Channel number
The started block search is not yet finished.
Text is deleted automatically after the end of the block search.
Wait until the block search has finished or trigger an NC reset.
Internal
Conflict between search type and search target!
The search target entered is not compatible with the search type:
The block number initial character "N" or ":" is missing,
only the digits 0 to 9 are allowed.
Correct the entry to correspond with the type.
The following is valid up to SW 3.x: The faulty entry is deleted, and the cursor proceeds to
the next field.
As of SW 4.1: The faulty entry is retained, and the cursor remains at the field.
Internal
Invalid file name
The file name entered:
Must not have more than 32 characters (letters, digits, underscore; including the block
and program ID:_N_ and _MPF), amounts to 25 assignable characters.
Cannot have any separators (e.g. /).
Must have letters at the first and second position.
--
Internal
No program selected - block search finished
At the moment, no program is selected, therefore, no search run is possible.
Select a program.
Internal
Please reference the axis first
The reference point approach was not yet performed or finished.
Perform reference point approach.
Internal
Current tool not found
If the cursor in the window "Magazine list" is at a blank line, then no tool will be found after
pressing the softkey "Tool data".
Place the cursor on the tool.
Internal
No other tools available
After pressing the softkey "T No. +" or "T No. -" the next-highest or next-lowest tool num-
ber is searched for.
If no other tools are available, this message will be output.
--
Internal
1 Alarms
1-499