Siemens SINUMERIK 840D Diagnostics Manual page 48

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
4184
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4185
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4200
Parameters:
Definitions:
1-48
In the specified machine data, a number has been used several times for the configura-
tion of an M function.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check the specified machine data and create a unique assignment of M auxiliary function
numbers.
Switch control OFF - ON.
Channel %1 illegally predefined auxiliary function in %2%3, MD reset
%1 = Channel number
%2 = MD identifier
%3 = If required, MD index
In the specified machine data, a predefined auxiliary function has been illegally config-
ured.
The value set by the user has been reset to the default value by the system.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Configure a valid value in the specified machine data.
Clear alarm with the RESET key. Restart part program.
Channel %1 illegal auxiliary function configured %2 %3 %4
%1 = Channel number
%2 = Type of auxiliary function
%3 = Extension
%4 = Auxiliary function value
An auxiliary function has been illegally configured.
Predefined auxiliary functions cannot be reconfigured by user-defined auxiliary functions.
- Mode group not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Reconfigure the auxiliary function.
Clear alarm with the RESET key. Restart part program.
Channel %1 geometry axis %2 must not be declared a rotary axis
%1 = Channel number
%2 = Axis name
The geometry axes represent a Cartesian coordinate system and therefore the declara-
tion of a geometry axis as rotary axis leads to a definition conflict.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04