Siemens SINUMERIK 840D Diagnostics Manual page 565

10.04
Remedy:
Program Continuation:
300702
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300703
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
• Reset motor data.
• Back up boot drive.
• Repeat the Power ON.
Switch control OFF - ON.
Axis %1 drive %2 base cycle time invalid
%1 = NC axis number
%2 = Drive number
The base cycle time set on the NC was too high for the drive.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
840D: NCK RESET. After powering up the system again, the NCK machine data 10 050:
$MN_SYSCLOCK_CYCLE_TIME (system base cycle) and MD 10080:
$MD_SYSCLOCK_SAMPL_TIME_RATIO (division factor of position control cycle for
actual value acquisition) are also modified automatically so that the limits are respected.
840C: Change the base cycle on the NC in MD 168.
Switch control OFF - ON.
Axis %1 drive %2 current cycle time invalid
%1 = NC axis number
%2 = Drive number
In the drive MD 1000: $MD_CURRCTRL_CYCLE_TIME.
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Please inform the authorized personnel/service department.
The following values are permissible:
611D control module Current controller cycle
• Standard control as 1-axis: >= 125 µs
• Standard control as 2-axis: >= 125 µs
• Performance 1-axis: >= 62.5 µs
• Performance 2-axis: >= 125 µs
• 810D: >= 156.25 µs
• MCU: >= 125 µs
• Performance 2: >= 31.25 µs
Switch control OFF - ON.
1 Alarms
1-565