Siemens SINUMERIK 840D Diagnostics Manual page 434

1 Alarms
61215
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61216
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61217
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61218
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-434
Channel %1 block %2 raw dimension incorrectly programmed
%1 = Channel number
%2 = Block number, label
Alarm triggered by following cycle: CYCLE76, CYCLE77.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
--
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 feed/tooth only possible with milling tools
%1 = Channel number
%2 = Block number, label
Feed per tooth is only possible with milling tools. Alarm triggered by following cycles:
E_TFS, F_TFS.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
As alternative, set a different feed type.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 cutting speed for tool radius 0 programmed
%1 = Channel number
%2 = Block number, label
To be able to work with cutting speed, the tool radius has to be specified. Alarm triggered
by following cycles: E_TFS, E_DR_TAP, F_TFS, F_DR_TAP.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter a value for cutting speed.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 feed/tooth programmed, but number of teeth is zero
%1 = Channel number
%2 = Block number, label
For feed per tooth, the number of teeth has to be specified. Alarm triggered by following
cycles: E_TFS, E_DR_BGF, F_TFS.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter the number of teeth on the milling tool in the "Tool list" menu.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04