Siemens SINUMERIK 840D Diagnostics Manual page 509

10.04
111001
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111002
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111003
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111004
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111005
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
111006
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Non-interpretable step in line %1
%1 = Line number
The step is not an element of ManualTurn.
Easystep sequencer is not loaded.
- Alarm display.
Delete the program step or change the program in the operating area PROGRAMS in the
SINUMERIK 840D or 810D (CNC mode).
Internal
Insufficient memory, abort in line %1
%1 = Line number
Easystep sequencer has too many steps.
Easystep sequencer is not loaded.
- Alarm display.
Change the program in the operating area PROGRAMS in the SINUMERIK 840D or 810D
(CNC mode).
Internal
ManualTurn: %1
%1 = Error code
Internal system message over the ManualTurn operator panel.
- Alarm display.
Acknowledge error and inform Siemens.
Internal
File faulty or not available: %1
%1 = File/Contour name
Easystep sequencer cannot interpret a step with contour programming.
Contour not in the directory.
- Alarm display.
Load contour into the directory.
Internal
Error when interpreting the contour %1
%1 = Contour name
Contour is faulty.
- Alarm display.
Check the contour's machining sequence.
Internal
Maximum number of contour elements exceeded %1
%1 = Contour name
The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
- Alarm display.
Check the contour's machining sequence and, if necessary, edit it.
Internal
1 Alarms
1-509