Siemens SINUMERIK 840D Diagnostics Manual page 343

10.04
Reactions:
Remedy:
Program Continuation:
21800
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22000
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
22010
Parameters:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 workpiece setpoint %2 reached
%1 = Channel number
%2 = Workpiece setpoint
This alarm is activated via MD 27880 PART_COUNTER, bit 1:
The number of counted workpieces ($AC_ACTUAL_PARTS or $AC_SPECIAL_PARTS)
is equal or already larger than the programmed value for the number of required work-
pieces ($AC_REQUIRED_PARTS).
At the same time, the channel VDI signal "Workpiece setpoint reached" is output.
The value for the number of the counted workpieces ($AC_ACTUAL_PARTS) is reset
while the value of $AC_SPECIAL_PARTS remains.
- NC not ready.
- Interface signals are set.
- Alarm display.
No program interrupt. Delete alarm display.
Clear alarm with the Delete key or NC START.
Channel %1 block %3 spindle %2 gear stage change not possible
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
A gear stage change for the spindle will not be possible, if:
- thread cutting (G33, G34, G35) is active
- the spindle is active as master or slave spindle in a coupling
- the spindle is being positioned
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The gear stage is to be set prior to the corresponding machining step.
If it is necessary, however, to change the gear stage within one of the above mentioned
functions, this function must be switched off for the time of the gear stage change. Thread
cutting is deselected with G1; synchronous spindle coupling is switched off with
COUPOF; the spindle positioning operation is exited with M3, M4 or M5.
Clear alarm with the RESET key. Restart part program
Channel %1 block %3 spindle %2 actual gear stage differs from requested gear
stage
%1 = Channel number
%2 = Spindle number
%3 = Block number, label
1 Alarms
1-343