Siemens SINUMERIK 840D Diagnostics Manual page 418

1 Alarms
Definitions:
Reactions:
Remedy:
Program Continuation:
61007
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61009
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61010
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-418
The tool radius is too large for machining. Alarm triggered by following cycles:
CYCLE930, CYCLE951, E_CP_CE, E_CP_CO, E_CP_DR, E_PO_CIR, E_PO_REC,
F_CP_CE, F_CP_CO, F_CP_DR, F_PO_CIR, F_PO_REC.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a smaller tool.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 tool radius too small
%1 = Channel number
%2 = Block number, label
The tool radius is too small for machining. Alarm triggered by following cycles: CYCLE92,
E_CP_CO, E_SL_CIR, F_CP_CO, F_PARTOF, F_SL_CIR.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Select a larger tool.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 active tool number = 0
%1 = Channel number
%2 = Block number, label
No tool (T) has been programmed before the cycle call. Alarm triggered by following
cycles: CYCLE71, CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Program tool (T).
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 finishing allowance too large
%1 = Channel number
%2 = Block number, label
The finishing allowance for the base is greater than the total depth. Alarm triggered by fol-
lowing cycle: CYCLE72.
- Alarm display.
- Interface signals are set.
- NC Start disable in this channel.
- Interpreter stop
Reduce finishing allowance.
Clear alarm with the RESET key. Restart part program
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04