Siemens SINUMERIK 840D Diagnostics Manual page 427

10.04
61176
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61177
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61178
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61179
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 Text length _DF has been programmed too short
%1 = Channel number
%2 = Block number, label
The text length in the engraving cycle is too short. This means that the text for engraving
is longer than the specified text length.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter longer text length
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Polar text length larger than 360 degrees
%1 = Channel number
%2 = Block number, label
In the engraving cycle, the polar text length must not exceed 360 degrees.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter shorter text length.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Code page is not available
%1 = Channel number
%2 = Block number, label
The specified code page is not supported by the cycle.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Use code page 1252.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Character does not exist, no.: %4
%1 = Channel number
%2 = Block number, label
%4 = Character number
The character entered in the text for engraving cannot be milled.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Enter another character.
Clear alarm with the RESET key. Restart part program
1 Alarms
1-427