Siemens SINUMERIK 840D Diagnostics Manual page 34

1 Alarms
4023
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4024
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4025
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
4026
Parameters:
Definitions:
1-34
Axis container %1 switch not allowed, axis container %2 switch active
%1 = Axis container
%2 = Axis container
Only one axis container can be rotated at a time.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Program must be canceled with Reset and the program sequences (NCUs, channels)
must be synchronized such that only one axis container switch is active at a time.
Clear alarm with the RESET key. Restart part program.
Invalid axis configuration due to missing axis container machine data
%1 = NCU number
%2 = Axis container number
The axis configuration could not be generated due to missing axis container machine
data. This error can only occur as a result of a communication error. The communication
failure will be indicated separately by further alarms.
- NC not ready.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Correct the link communication problems (refer to the other alarm messages).
Switch control OFF - ON.
Axis container %3 switch not allowed: master/slave active channel %1 axis %2
%1 = Channel
%2 = Axis/spindle
%3 = Axis container number
It is not possible to enable axis container switch as a master/slave link is active.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Abort program with the RESET key. If required, disconnect the master - slave coupling.
Clear alarm with the RESET key. Restart part program.
Machine data %1[%2], link axis NC%3_AX%4 not used by any channel
%1 = String: MD identifier
%2 = Index: MD array
%3 = NCU number
%4 = Machine axis number
The link axis is not referenced by any channel.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04