Siemens SINUMERIK 840D Diagnostics Manual page 494

1 Alarms
Definitions:
Remedy:
Program Continuation:
101154
Definitions:
Remedy:
Program Continuation:
101155
Parameters:
Definitions:
Remedy:
Program Continuation:
101156
Definitions:
Remedy:
Program Continuation:
101157
Parameters:
Definitions:
Remedy:
Program Continuation:
101158
Definitions:
Remedy:
Program Continuation:
101159
Definitions:
Remedy:
Program Continuation:
101160
Definitions:
Remedy:
Program Continuation:
1-494
In the start-up area the softkey "Calculate controller data", for example, was pressed.
An unspecific error message is sent from the NCK or drive as acknowledgement for this
function call.
By using the two hexadecimal values (error class, error code), the start-up engineer can
perform an error diagnostics.
--
Internal
PI service was rejected
The current status of the NKC/drive does not permit the function that was selected.
See the Installation and Start-up Guide.
Internal
Path %1 not available
%1 = Path
During a file function, e.g.saving boot files, an attempt was made to access a non-existent
path.
Switch the control OFF/ON or see the Installation and Start-up Guide.
Switch control OFF - ON.
Impermissible function
The selected function is impermissible.
See the Installation and Start-up Guide.
Internal
File %1 not available
%1 = File name
In the start-up area the softkey "delete boot files", for example, was pressed, although no
boot files are yet available.
--
Internal
Function not permitted in the current operating state.
The drive's current status does not permit this function.
--
Internal
Remote block in wrong state
The drive's current status does not permit this function.
--
Internal
Date and time of the PLC set
In the PLC status, the time or date was changed.
--
Internal
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04