Siemens SINUMERIK 840D Diagnostics Manual page 333

10.04
20160
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20170
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20200
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
20201
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 tool management: PLC can terminate only incorrectly aborted com-
mands
%1 = Channel number
Indication that the PLC wanted to interrupt an active command from the tool management
(tool change); or that there is no command active for abort. NCK refuses because the
channel status is either 'active' (abort is then not allowed), or 'reset' (then there is nothing
to abort).
- Interface signals are set.
- Alarm display.
For information only.
Clear alarm with the Delete key or NC START.
Channel %1 machine data $AC_FIFO invalid
%1 = Channel number
The structure of the FIFO variable $AC_FIFO - $AC_FIFO10 determined by the machine
data $MC_NUM_AC_FIFO, $MC_START_AC_FIFO, $MC_LEN_AC_FIFO and
$MC_MODE_AC_FIFO cannot be stored in the R parameter field defined in
$MC_MM_NUM_R_PARAM.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Increase the number of the R
parameters or reduce the FIFO elements.
$MC_MM_NUM_R_PARAM = $MC_START_AC_FIFO + $MC_NUM_AC_FIFO x
($MC_LEN_AC_FIFO + 6)
Switch control OFF - ON.
Channel %1 invalid spindle number %2 with tool fine compensation
%1 = Channel number target channel
%2 = Spindle number
There is no spindle/axis assignment in the target channel for the spindle specified in the
PUTFTOC command.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Modify program in channel that writes the tool fine compensation.
Clear alarm with the RESET key. Restart part program
Channel %1 spindle %2 no tool assigned
%1 = Channel number
%2 = Spindle number
In order to make allowance for the fine tool compensation for the tool currently in the spin-
dle, a spindle/tool assignment must be active. This is not presently the case for the pro-
grammed spindle in the target channel of fine tool compensation.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1 Alarms
1-333