Siemens SINUMERIK 840D Diagnostics Manual page 375

10.04
Remedy:
Program Continuation:
26031
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
26032
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
26050
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Please inform the authorized personnel/service department. Rereferencing/resynchroni-
zation of the absolute encoder; attach absolute encoder on the load side and configure
correctly (e.g. MD 31040 ENC_IS_DIRECT).
If an absolute encoder with serial number is replaced, the drive BOT file for this drive must
be saved (due to the new serial number).
Clear alarm with the RESET key in all channels of this mode group. Restart part program.
Axis %1 configuration error master-slave
%1 = Axis name, spindle number
The alarm is output when the same machine axis has been configured as a master and a
slave axis. Each of the axes in the master/slave link can be operated either as master or
slave.
- Mode group not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
• Check machine data for all linked axes and correct if necessary:
• MD 37250 $MA_MS_ASSIGN_MASTER_SPEED_CMD
• MD 37252 $MA_MS_ASSIGN_MASTER_TORQUE_CTR.
Clear alarm with the RESET key. Restart part program
Axis %1 master-slave not configured
%1 = Axis name, spindle number
The master-slave coupling could not be activated because of incomplete configuration.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Check the current configuration of the master-slave coupling.
The configuration can be modified via the MASLDEF instruction or the machine data
MD37250 $MA_MS_ASSIGN_MASTER_SPEED_CMD and MD37252
$MA_MS_ASSIGN_MASTER_TORQUE_CTR.
Clear alarm with the RESET key. Restart part program
Axis %1 parameter set change from %2 to %3 not possible
%1 = Axis name, spindle number
%2 = Index: current parameter block
%3 = Index: new parameter block
The parameter block change cannot be performed without jumps. This is due to the con-
tent of the parameter block to be switched on, e.g. different load gear factors.
- The NC switches to follow-up mode.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
1 Alarms
1-375