Siemens SINUMERIK 840D Diagnostics Manual page 124

1 Alarms
Reactions:
Remedy:
Program Continuation:
10794
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10795
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10800
Parameters:
1-124
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 angle specification missing in second block during linear
interpolation with angles
%1 = Channel number
%2 = Block number, label
The angle is missing from the second block during programming of two straight lines with
angle specification. This error can only occur if an angle was programmed in the preced-
ing block, but no axis of the active plane was programmed in that block. The cause of the
error may therefore also have been the intention to program a single straight line with an
angle in the previous block. In this case, exactly one axis of the active plane must be pro-
grammed.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 end point specification during angle programming contradic-
tory
%1 = Channel number
%2 = Block number, label
During programming of a straight line, both positions of the active plane and an angle
were specified (the position of the end point is over-specified), or the position of the pro-
grammed coordinate cannot be reached with the specified angle. If a contour consisting of
two straight lines is to be programmed with angles, it is possible to specify the two axis
positions of the plane and an angle in the second block. The error can also occur if, due to
a programming error, the preceding block cannot be interpreted as the first subblock of
such a contour. A block is interpreted as the first block of a two-block contour if an angle,
but not an axis of the active plane, was programmed, and if the block is not already the
second block of a contour.
- Correction block is reorganized.
- Local alarm reaction.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm at block end.
Modify part program.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %3 axis %2 is not a geometry axis
%1 = Channel number
%2 = Axis name, spindle number
%3 = Block number, label
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04