Siemens SINUMERIK 840D Diagnostics Manual page 589

10.04
300760
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300761
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
300762
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Axis %1 drive %2 generator mode: emergency retraction speed > max. motor speed
%1 = NC axis number
%2 = Drive number
The value entered for the emergency retraction speed in MD1639:
$MD_RETRACT_SPEED (emergency retraction speed) is greater than MD1146:
$MD_MOTOR_MAX_ALLOWED_SPEED (maximum motor speed).
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Please inform the authorized personnel/service department.
Modify drive machine data
• Modify MD 1639: $MD_RETRACT_SPEED (emergency retraction speed) or
• Modify MD 1146: $MD_MOTOR_MAX_ALLOWED_SPEED (maximum motor speed).
Clear alarm with the RESET key in all channels. Restart part program.
Axis %1 drive %2 generator mode: minimum axis speed > max. motor speed
%1 = NC axis number
%2 = Drive number
The value in MD1635: $MD_GEN_AXIS_MIN_SPEED $MD_GEN_AXIS_MIN_SPEED
(minimum generator axis speed) is greater than the value in MD1146:
$MD_MOTOR_MAX_ALLOWED_SPEED (maximum motor speed).
- NC not ready.
- The NC switches to follow-up mode.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
- Channel not ready.
Please inform the authorized personnel/service department.
Modify drive machine data
• Modify MD 1635: $MD_GEN_AXIS_MIN_SPEED generator axis) or
• Modify MD 1146: $MD_MOTOR_MAX_ALLOWED_SPEED (maximum motor speed).
Clear alarm with the RESET key in all channels. Restart part program.
Axis %1 drive %2 emergency retraction mode/generator mode already active
%1 = NC axis number
%2 = Drive number
Emergency retraction or generator mode already active.
The alarm can be reprogrammed in the MD ALARM_REACTION_CHAN_NOREADY
(channel not ready).
1 Alarms
1-589