Siemens SINUMERIK 840D Diagnostics Manual page 523

10.04
112505
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
112506
Definitions:
Reactions:
Remedy:
Program Continuation:
112541
Definitions:
Reactions:
Remedy:
Program Continuation:
112543
Definitions:
Reactions:
Remedy:
Program Continuation:
112544
Definitions:
Reactions:
Remedy:
Program Continuation:
112601
Definitions:
Reactions:
Remedy:
Program Continuation:
112604
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Error when interpreting the contour %1
%1 = Contour name
Contour is faulty.
- NC Start disable in this channel.
- Alarm display.
Check the contour's machining sequence.
Internal
Maximum number of contour elements exceeded %1
The maximum permissible number of 50 contour elements was exceeded when interpret-
ing the machining sequence of a contour.
- Alarm display.
Check the contour's machining sequence and, if necessary, edit it.
Internal
Program cannot be interpreted
The program cannot be interpreted as a ShopMill program during loading, as the program
header is missing.
- NC Start disable in this channel.
- Alarm display.
--
Internal
Progr. has been created with higher software version
The part program has been created with a software version higher than the existing one.
- Alarm display.
Delete the machining step and reprogram machining if required.
Clear alarm with the Delete key or NC START.
Program cannot be opened. It is already being edited.
Program is already open in HMI Advanced (Program or Services operating area).
- Alarm display.
Close program in HMI Advanced (Program or Services operating area).
Clear alarm with the Delete key or NC START.
ShopTurn XXXX
A system error has occurred.
- Alarm display.
Please contact the hotline of Siemens AG, A&D MC and provide with the error message.
Clear alarm with the Delete key or NC START.
Connection to the PLC broken off
Acknowledgement to the PLC user program, that the connection with the PCU has been
broken off.
ShopMill PLC is terminated.
- Alarm display.
Check the PLC user program.
Internal
1 Alarms
1-523