Siemens SINUMERIK 840D Diagnostics Manual page 19

10.04
1030
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1031
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1100
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
System error in link module error code %1 error type %2
%1 = Hex-Zahl Link-Error
%2 = Hex-Zahl Link-Error-Type
This alarm is not a user error. An internal error has occurred in the software of the link
module. Two parameters are output with this error for debugging purposes. They provide
information about the cause and location of the error.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Switch control OFF - ON.
Link module generated an unspecified error %1 NCU %2 %3 %4
%1 = Hex-Zahl unspecified status in stateOfLinkModules
%2 = NCU number
%3 = Command from link module to NCK
%4 = Status of own link
This alarm is not a user error.
• 1. If NCU== 0 -> A parameter not equal to zero was not found
• 2. If NCU not equal to zero -> An error which the NC was not able to interpret in the con-
nection to this NCU. The error is output as a number. It is possible that the NCU link mod-
ule is running a newer software version than the NC.
The other parameters are used for error localization in the NC/LINK-MODUL software.
- NC not ready.
- Channel not ready.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
- NC Stop on alarm.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Switch control OFF - ON.
No valid firmware
No memory card or memory card without valid firmware (license) inserted.
- Alarm display.
Make a note of the error text and contact Siemens AG A&D MC, Hotline (tel./fax: see
alarm 1000)
Switch control OFF - ON.
1 Alarms
1-19