Siemens SINUMERIK 840D Diagnostics Manual page 477

10.04
Reactions:
Remedy:
Program Continuation:
70018
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
75000
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
No channel axis defined. In MD 20070 at least 1 channel axis must be entered.
Error code = 6
Problem on saving when creating the compile cycle machine data, modification of
MD 18238 required (SW 6 and higher)
Error code = 10
One of the direction vectors in MD 62113-5 is too short.
Error code = 12
One rod length Li in MD 62120-2 equals zero.
- Interpreter stop
- NC Start disable in this channel.
- Alarm display.
Correct machine data
Clear alarm with the RESET key. Restart part program
Channel %1 Transformation was selected with non-referenced axes
%1 = Channel number
In order to guarantee proper operation of the transformation, the two linear axes involved
in the transformation have to be referenced prior to selection of the transformation. This
alarm is output at the first traversing movement after selection of the transformation.
- NC Start disable in this channel.
- Alarm display.
- NC Stop on alarm.
Reference the machine axes; deselect and reselect the transformation
Clear alarm with the RESET key. Restart part program
CLC: incorrect MD configuration, channel %1, error code: %2
On ramp-up the following error was found in the clearance control machine data:
Error code = -1:The intermediate points of one of the two sensor characteristics are not
rising or falling strictly monotonously.
Error code = -2:One of the two sensor characteristics has less than 2 valid intermediate
points.
Error code = -3:One of the two sensor characteristics has more than 5 intermediate points
with negative velocity or more than 5 intermediate points with positive velocity.
Error code = -4:The digital input for sensor collision monitoring as set in MD $MC_
CLC_SENSOR_TOUCHED_INPUT has not been activated on the control (10350
$MN_FASTIO_DIG_NUM_INPUTS)
Error code = -5:No rapid input was assigned to the special function "Fast retraction in the
position controller" via MD $MC_CLC_SENSOR_TOUCHED_INPUT.
Error code = -6:The axis selected for the clearance control in MD $MC_CLC_AXNO is not
active in the channel.
Error code = -7:The 5-axis transformation (24100 $MC_TRAFO_TYPE_x) selected for the
clearance control in MD $MC_CLC_AXNO is not configured in the channel.
Error code = -8:More than one of the axes involved in the clearance control is the master
axis of a gantry grouping 37100 $MA_GANTRY_AXIS_TYPE
Error code = -9:One of the axes involved in the clearance control is the slave axis of a
gantry grouping 37100 $MA_GANTRY_AXIS_TYPE
Error code = -10: Export versions will only enable activation of an axial clearance control,
if less than four simultaneously interpolating axes have been configured.
1 Alarms
1-477