Siemens SINUMERIK 840D Diagnostics Manual page 249

10.04
Reactions:
Remedy:
Program Continuation:
16100
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16105
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
16110
Parameters:
Definitions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Modify the part program if necessary.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 spindle %3 not available in the channel
%1 = Channel number
%2 = Block number, label
%3 = String
Mistake in programming: This channel does not recognize the spindle number. The alarm
can occur together with a dwell or SPI function.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
Please inform the authorized personnel/service department. Check the part program to
determine whether the programmed spindle number is correct and whether the program
is run in the correct channel.
Check MD 35000 SPIND_ASSIGN_TO MACHAX for all machine axes to see whether
one of them contains the programmed spindle number. This machine axis number must
be entered in a channel axis of the channel-specific machine data 20070
AXCONF_MACHAX_USED.
Clear alarm with NC START or RESET key and continue the program.
Channel %1 block %2 spindle %3 cannot be assigned
%1 = Channel number
%2 = Block number, label
%3 = String
Mistake in programming: The programmed spindle is not assigned a real axis by the spin-
dle number converter. The alarm can be issued after improper use of
$SC_SPIND_ASSIGN_TAB[].
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Correct setting data or modify part program.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 spindle %3 for dwell time not in control mode
%1 = Channel number
%2 = Block number, label
%3 = Axis, spindle
The spindle can be in the positioning mode, oscillating mode and control mode. With the
M command M70 it can be changed from a spindle to an axis. The control mode is divided
into the speed-controlled and position-controlled mode, and it is possible to alternate
between these with the keywords SPCON and SPCOF.
Positioning mode:
Position control (spindle position under SPOS/SPOSA)
Oscillating mode:
1 Alarms
1-249