Siemens SINUMERIK 840D Diagnostics Manual page 293

10.04
17192
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17193
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
17194
Parameters:
Definitions:
Reactions:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
TO unit %1 invalid tool designation of '%2', duplo no. %3. No more replacement
tools possible in '%4'.
%1 = TO unit
%2 = Tool identifier
%3 = Duplo number
%4 = Group identifier
The tool with the specified tool identifier, duplo number cannot accept the group identifier.
Reason: The maximum number of replacement tools allowed has already been defined.
The name allocation causes the tool to be reallocated to a tool group which already con-
tains the maximum number of replacement tools allowed on this machine.
- Interface signals are set.
- Alarm display.
Use fewer replacement tools or request a different maximum setting from the machine
manufacturer.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 the active tool is no longer on toolholder no./spindle no. %3,
program %4
%1 = Channel number
%2 = Block number, label
%3 = Toolholder no., spindle no.
%4 = Program name
The tool at the specified toolholder/spindle at which the last tool change was carried out
as master toolholder or master spindle, has been replaced.
Example:
N10 SETHTH(1)
N20 T="Wz1" ; Tool change at master toolholder 1
N30 SETMTH(2)
N40 T1="Wz2" ; Toolholder 1 is only a secondary toolholder.
Changing the tool does not result in correction deselection.
N50 D5; New correction selection. At present, there is no active tool which D can refer to,
i.e. D5 refers to T no. = 0, which results in zero correction.
- Interface signals are set.
- Alarm display.
• Modify program:
• Set desired spindle as master spindle or toolholder as master toolholder.
• Then, if required, reset master spindle or master toolholder.
Clear alarm with the Delete key or NC START.
Channel %1 block %2 no suitable tool found
%1 = Channel number
%2 = Block number, label
• An attempt was made to access a tool which has not been defined.
• The specified tool does not permit access.
• A tool with the desired properties is not available.
- Correction block is reorganized.
- Interface signals are set.
- Alarm display.
1 Alarms
1-293