Siemens SINUMERIK 840D Diagnostics Manual page 132

1 Alarms
Reactions:
Remedy:
Program Continuation:
10932
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10933
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
10934
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
1-132
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
The errors listed above must be corrected in the subroutine for the stock removal contour.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 preparation of contour has been restarted
%1 = Channel number
%2 = Block number, label
The first contour preparation/contour decoding run must be terminated with EXECUTE.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Program the keyword EXECUTE to terminate the contour preparation in the part program
before again calling up contour segmentation (keyword CONTPRON).
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 contour program does not contain enough contour blocks
%1 = Channel number
%2 = Block number, label
The contour program contains:
• Less than 3 contour blocks with CONTPRON
• No contour blocks with CONTDCON
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Increase the size of the subroutine with the stock removal contour to include at least 3 NC
blocks with movements in both axes of the current machining plane.
Clear alarm with the RESET key. Restart part program.
Channel %1 block %2 array for contour segmentation is set too small
%1 = Channel number
%2 = Block number, label
During contour segmentation (activated with the keyword CONTPRON), the field for the
contour table has been detected as too small. For every permissible contour element (cir-
cle or straight line) there must be a row in the contour table.
- Local alarm reaction.
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Base the definition of the field variables of the contour table on the contour elements to be
expected. The contour segmentation function divides up some NC blocks into as many as
3 machining cuts. Example: N100 DEF TABNAME_1 [30, 11] Field variables for the con-
tour table provide for 30 machining cuts. The number of columns (11) is a fixed quantity.
Clear alarm with the RESET key. Restart part program.
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
10.04