Siemens SINUMERIK 840D Diagnostics Manual page 453

10.04
61361
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61362
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61363
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
61364
Parameters:
Definitions:
Reactions:
Remedy:
Program Continuation:
 Siemens AG, 2004. All rights reserved
SINUMERIK 840D/840Di/810D Diagnostics Guide (DA), 10.04 Edition
Channel %1 block %2 Variable cannot be logged
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE105.
The value specified in _PROTVAL[] cannot be logged.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Number of values too large
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE118.
4th parameter for CYCLE118 is larger than 10.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Max. no. of value lines exceeded
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE105.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
Reduce the number of lines.
Clear alarm with the RESET key. Restart part program
Channel %1 block %2 Max. no. of value lines exceeded
%1 = Channel number
%2 = Block number, label channel number
The alarm is triggered by the following cycles: CYCLE998.
Parameter _ID is <= 0.
- Interpreter stop
- NC Start disable in this channel.
- Interface signals are set.
- Alarm display.
-
Clear alarm with the RESET key. Restart part program
1 Alarms
1-453